The first uses non corrosive metal screws.
Attaching wood shutters to vinyl siding.
Do not over tighten or this will cause the shutter to dimple.
You ll need a masonry bit and masonry wall anchors or suitable spikes if provided with shutters.
To remove shutters do not attempt to pull out the shutter spikes.
To avoid warping don t attach the shutters tightly.
Grasp the shutter fastener supporting shank and push it through the shutter hold and into the wall surface.
Screws are used to attach outdoor shutters to wood vinyl and other soft siding.
Most vinyl siding is made to imitate wood lap siding so the lap of the siding is measured at the bottom of the simulated wood panel where the real wood would overlap each other.
The second approach employs a vinyl spike.
Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw.
Tap the shutter fastener gently with a hammer to snug the shutter against the siding.
There are two methods of installing vinyl exterior shutters.
Reposition the shutter on the wall.
Use a drill with a multi purpose 11 64 inch bit to pre drill holes through the shutter for the screws at each reference mark.
Shutter inches in a lawn mower baseball hail damage or shutters wooden exterior shutters all i have or a pilot holes through the vinyl or carpentry skills consider adding shutters on the size of a inch larger than wood window.
How to hang shutters on vinyl siding attach the shutters may end standardsized vinyl and inch diagonally from the market.
When the siding needs to expand it would become distorted in the middle since it would not be able to expand left or right due to being pinned at both ends.
The shutters on the left of one window and the shutters on the right of the other would be attached to the same piece of siding which would then be pinned at both ends with screws.
Also drill the hole in the siding 1 4 inch larger than the fastener.
Step 3 add these two measurements together then add 1 2 inch.
Measure the thickness of the lap on the siding.
Approximately 5 inches from the shutter s top is an ideal location for screws.